In theShop
Quick-action repetitive clamps
By William Sampson
wsampson@wattnet.net
New line of clamps from Lidwig is
designed to meet a wide range of
production needs

220-pound clamping force. Two more clamps from Lidwig use the same clamping principle but with aluminum alloy construction. That boosts clamping power to 440 pounds. The X6 has a 2-inch clamp capacity with 4-inch throat. The

X7 uses a sliding bar mechanism to increase capacity to 12 inches with a 4-inch throat.

Custom work often requires custom clamping. But, in the case of cabinetry, just as often there is some redundancy in the clamping requirements. Maybe you have the same setup to do over several times or you might have a jig or fixture that needs a hold-down clamp for several operations on similar parts. Most of these chores present challenges for conventional clamps with time-sapping screw mechanisms. The new line of Lidwig clamps from Australia offers an innovative

solution. Quick, repetitive clamps

— New clamps from Lidwig offer a quick clamping mechanism that makes for sure and precise clamping over and over again.

Hybrid design

Lidwig clamps offer a unique hybrid design that combines some of the best attributes of several clamps. The basic concept is to marry a screw adjustment with a quick-action handgrip. The clamps work a lot like common locking pliers but with a lot more range of adjustment.

To add further versatility, the clamps come in several configurations. The smallest is the X4 model, which is made of tough glass resin construction and has a clamping capacity of just over 2 inches and throat depth about the same. It clamps with a force of 220 pounds, which is plenty for most jig and fixture applications.

The X5 model is similar to the X4 with the same throat depth but uses a sliding bar with pin-locked stops to increase capacity up to about 6 inches. It grips with the same

Trying them out

These clamps work a lot like common locking pliers. You set the screw for the force and capacity you want and then close the grip levers to activate the clamp. The beauty of the system shows through in any repetitive operation, since you get exactly the same clamping force and the clamp is set precisely for the job.

These work great as hold-downs on drill presses or to grip a workpiece in a fixture. They are very handy for repetitive operations on the benchtop, such as sanding a bunch of similar parts.

The clamps have non-marring cauls
to protect workpieces from damage. Because the clamp-
ing force is applied in line instead of at an angle or with a
screw, these clamps are a lot easier to place exactly where
you want them.

They are also designed to resist vibration.

For more information about the clamps, visit www. lidwig.com.au. ◻

Go to
www.cabinetmakeronline.
com/ lidwig.aspx to see these
clamps in action.